Gerber Technology GERBERplotter MP Series User Manual

78
GERBERplotter MP Series User Manual
English
The CUT PAUSE switch has a similar behavior to CUT PLUS, but, in this case, the paper does not advance immedi-
ately.
After printing a cut line, printing resumes normally. Once the cut line reaches the cutting zone, the plotter stops
printing, allowing the user to remove the job without wasted paper.
CUT PAUSE modier
2
At the end of a job, if the next job in the print queue has
a CUT PAUSE modier, a dashed line indicating the cut
is printed. Then, printing resumes normally after a little
paper advance.
1
From User Manager, go to the printing queue and add
the CUT PAUSE modier after the job you want to
extract.
User Man-
3
Once the cut line reaches the cutting zone, the plotter
stops. This lets you cut and remove the job. To cut the
paper, slide the cutter from right to left using its handle.
4
After the job is extracted, press the PRINT/PAUSE but-
ton so the plotter can print again.
5
After printing a few centimeters, the plotter stops again.
Fasten the paper using the side and center clips.
6
Finally, press the PRINT/PAUSE button to exit the
paused state and print new jobs.
PRINT
PAUSE
PRINT
PAUSE

Gerber Technology GERBERplotter MP Series Specifications

General

Brand	Gerber Technology
Model	GERBERplotter MP Series
Category	Plotter
Language	English