102 Dimension 200
ROUTER MOTOR LUBRICATION
The router motor bearings are lubricated during assembly but
must be lubricated after every 1000 hours of operation. This
procedure refers to the High Frequency Spindle Motor Option
only.
1.
Use a lithium-based, NLGI grade 2 grease, such as Optimal
Longtime PD2 or Leuber Isoflex LDS 18 Special A.
CAUTION: Before lubricating the bearings, clean the grease
nipples carefully to prevent dust or dirt from entering the
motor.
2.
Lubricate each bearing with 2 grams of grease.
CAUTION: Do not over-lubricate. Over-lubrication will
cause excessive heat build-up.
3.
Weekly, clean and grease the cams with lithium-based or
white grease.
To Next Page
Loading...