16
Dimension 200
ARC Station
Connect Power Supply to ARC Station
1.
Plug the single-pronged end of the ARC station power cord
into the port labeled R831 on the ARC station (the other end
already connects to the power supply box). See the above
illustration.
2.
Locate the power cord and plug the three-slotted end into the
power supply box.
3.
Plug the three-pronged end of the power cord into either
receptacle labeled
ARC STATION/ACCESSORY
on the back of
the electrical box.
Connect Router Table to ARC Station
1.
Plug the 14-pin round X and Y limit switch connector from the
router table into the receptacle labeled R892 on the ARC
station. (See the illustration above.)
Connect Electrical Box to ARC Station
1.
Plug one end of the 37-pin to 37-pin cable into the receptacle
labeled R830 on the ARC station. Tighten the screws.
2.
Plug the other end into the receptacle labeled R846 on the
electrical box. Tighten the screws.
To Next Page
Loading...