Operating Principles 51
Z INIT
The Z INIT function key initializes the Z axis tool height above
the work surface. The Z INIT key may be used only when the
STOP JOB
or
STOP READY
message displays. You may use either
the tool height gage or the step height gage for initialization.
CAUTION: The Z axis must be set every time the tool or
material is changed. Failure to initialize the Z axis properly will
make the tool cut into the material at the wrong depth. This may
destroy the material and cause the tool to cut into the router
table.
CAUTION: Do not turn the Z axis knob after the Z axis has
been initialized.
To perform Z Init
1.
Place the step height gage on top of the material to be cut. (See
the procedure in this manual for “Using the Step Height
Gage.”)
2.
Slew the carriage to position the tool over the gage.
3.
Press the Z INIT key. The Z motor is now OFF to allow for
manual adjustment. The
Z UNLOCKED
message appears.
4.
Turn the Z axis knob to lower the tool until it just touches the
surface of the step height gage.
CAUTION: Excessive pressure will cause tool damage.
5.
Press Z INIT to raise the tool.
Note: If RESET is pressed, the Z motor locks and the Z INIT
process is exited.
6.
Remove the step height gage.
To Next Page
Loading...