System Preparation and Use 73
7.
Insert both the tool and collet into the opening at the base of the
router motor, as shown below.
8.
Hold the collet to prevent the tool from falling out and hand
tighten the retaining nut.
9.
Hold a wrench in one hand and place it on the flats of the
router motor chuck.
10.
Hold the other wrench in the opposite hand and place it on
the flats of the retaining nut.
11.
Tighten the retaining nut by pushing the wrenches with a firm
even force.
TOOL REMOVAL
CAUTION: When removing a tool, do not attempt to gain leverage
by jamming one wrench against the carriage while pushing on the
other.
DO NOT position the router motor over the router table without
any material underneath, such as foam board or a soft cloth. The
tool might fall out when the retaining nut is loosened and break or
damage the cutting edge.
To Next Page
Loading...