84
Dimension 200
CAUTION: Spray adhesive is sticky. Do not spray near the
router table.
To attach the workpiece to the sacrificial material
1.
Spray the adhesive in smooth, even strokes across the back of
the workpiece.
2.
Coat the entire surface uniformly, including edges and corners, until
tacky, but not wet.
3.
Press the workpiece firmly onto the sacrificial material.
Mounting the Workpiece
After adhering the material to sacrificial material, or if you are not
using sacrificial material, you may mount the workpiece on the
table using clamps, the T-Vac, or a combination of both.
USING CLAMPS
After the workpiece is adhered to the sacrificial material (if used),
attach the entire workpiece to the router table with work clamps.
Use all four work clamps to ensure that the workpiece is held
down securely. The clamps can be reversed so that they may be
used with either thick or thin material, as shown below.
Note: Your router may vary from the photographs.
To Next Page
Loading...