50
Dimension 200
RESET
The RESET function key immediately halts the job that is running.
In Start Mode
If in START JOB mode and the operator presses the RESET key:
the tool raises
the carriage X,Y travel stops
current job data from the router and the GRAPHIX
ADVANTAGE clears
the
STOP/READY
message displays.
In Menu Select Mode
RESET exits the menu without saving changes.
In Other Modes
If in any other mode and the operator presses the RESET key, the
ABORT ???
message appears.
To cancel the job, press the RESET key again.
To continue the job without data loss, press START/STOP.
To Next Page
Loading...