22
Dimension 200
Connect GRAPHIX ADVANTAGE to ARC Station
1.
Plug the 9-pin D-connector of the RS-232 cable into the port
labeled
PLOTTER
or
COM
at the rear of the GRAPHIX
ADVANTAGE. Carefully align all pins and press all the way
in.
2.
Tighten the connector thumb screws to secure the cable to the
system.
3.
Plug the 25-pin D-connector into the receptacle labeled R829
on the ARC station (see the illustration on page 16). Tighten
the thumb screws.
Power Connections
1.
Plug the power cord from the electrical box into an
appropriately grounded outlet.
2.
If necessary, plug in the router motor power cord into the
receptacle, as shown.
3.
Plug the shop vacuum into the duplex receptacle on the
electrical box labeled
SHOP VAC/BLOWER
.
4.
Turn ON power at the electrical box.
To Next Page
Loading...