Gerber Dimension 200 - Using T-Vac Vacuum Hold-Down

86
Dimension 200
USING T-VAC VACUUM HOLD-DOWN
The T-Vac Vacuum System reduces the need for adhesives and
sacrificial materials because it holds the workpiece securely on the
table without adhesives. With certain materials, you may wish to
use sacrificial material. T-Vac is not recommended for use with
very small workpieces, very thick or porous materials, or
materials with irregular surfaces.
CAUTION: IT IS ADVISABLE TO USE CLAMPS IN
ADDITION TO T-VAC VACUUM HOLD-DOWN IF THE
WORKPIECE IS THICK OR THE JOB IS LARGE TO PREVENT
ACCIDENTAL WORKPIECE MOVEMENT IF THE VACUUM
IS INTERRUPTED.