Gerber Dimension 200 - System Setup

Router Installation Procedure 23
5. Turn ON power at the GRAPHIX ADVANTAGE system.
The ARC station displays the message
SLEW TO THE POINT
OF ORIENTATION
in the display panel after performing
power-up diagnostics. The router system is now ready to
operate. Refer to the section on setting up the ARC station
later in this chapter.
6. Turn ON the router motor power switch when ready to cut.
Set Up the ARC Station
The ARC station can support several different routers. When you
first install your system, follow the procedure below to configure
the ARC station for the Dimension 200. (See page 39 for an
illustration of the front panel of the ARC station.)
1. With the main power switch off on the electrical box, press
and hold down the RESET and UP arrow keys on the ARC
station.
2. While holding these keys down, turn the main power switch
on.
3. Release the ARC station keys after the second beep. The
SYSTEM
: message appears.
4. Press SELECT.
5. Press the left or right arrow key until
DIMENSION 200
is
displayed.
6. Press SELECT.
7.
LIMIT SWITCH
displays. (Gerber recommends that the limit
switch be set to
ON
.)
8. Press SELECT.