Gerber Dimension 200 - Page 104

104 Dimension 200
arrows ............................................42
Reset ...............................................48
Select...............................................50
Start.................................................45
Start/Stop ......................................43
Stop.................................................45
Z Init.........................................36, 49
G
Gerber Cool coolant ...................25, 86
Grid engraving .................................73
grid numbers.................................75
normal ............................................73
with T-Vac .....................................76
Grid engraving data.........................73
Grid numbers....................................75
Ground strap cables.........................20
H
Hard metals.......................................78
High Frequency Spindle Option.4, 6,
25, 27, 31, 98
Home Position ..................................37
current............................................55
I
Initializing
Z Axis .............................................36
Inplace repeats..................................56
Installation
Chip Removal System..................18
Mist Coolant System ....................25
pressure foot..................................84
router..............................................15
router motor ..................................65
Speed Controller...........................30
T-Vac Vacuum System.................28
J
Job boundaries ..................................56
Job Home Position ...............37, 53, 56
L
Language...........................................60
Lead screws.................................92, 94
Low-tack tape ...................................79
M
Main power switch ..........................38
Mat milling data...............................72
Material selection .............................77
Menu Select mode............................48
Menu selection
Absolute X,Y .................................52
Default ...........................................61
Display...........................................60
Feed Rate .......................................57
Motor Delay ..................................59
Return Home ................................57
Set Job Home.................................53
Test .................................................59
Metals...........................................77, 78
Mist coolant
fluid level.......................................95
nozzle.............................................95
Mist Coolant System........................25
air pressure....................................86
compressed air................................4
drip rate adjustment ....................87
installation.....................................26
using...............................................86
Motor Delay ......................................59
N
Non-metals........................................79
O
Operating principles........................35
Orientation ..................................52, 59
Orientation point......41, 72, 74, 75, 77