46
Dimension 200
Start Job
When the job data is received, the
START JOB
message appears,
indicating that the Dimension 200 is in a “run” state. ART Path
sends a header or tool message, the system goes into STOP JOB
mode and instructs the operator to load material. Press
START/STOP again to display the tool assignment. To begin the
job, press START/STOP again.
WARNING: The carriage may move without further warning.
Stop Mode
STOP mode, as shown by a message in the display panel, may be
in one of two states:
STOP READY - the router is in an idle state waiting to receive
data
STOP JOB - the router is in a pause state during a job
The following keys are available in STOP mode:
START/STOP
RESET
Z INIT
SELECT
arrow keys
To Next Page
Loading...