60
Dimension 200
To change feed rate
CAUTION: The feed rate override is not cleared after the job
completes and will be applied to the next job received.
1.
Press SELECT while in the STOP READY or STOP JOB mode.
2.
Press the right or left arrow key until Feed Rate: appears in
the message box.
3.
Press SELECT to obtain the Feed Rate percentage.
4.
Press the right or left arrow keys to move the cursor to the
desired digit.
5.
Press the up or down arrow keys to increase or decrease the
digit under the cursor. Acceptable values are 1% to 1000%.
6.
Press SELECT to save the new value.
If the value is valid (1 - 1000%), the system beeps twice and
returns to the STOP READY or STOP JOB mode.
If the value is not valid, the display remains until a valid value
is entered or until RESET is pressed to exit the menu without
changing the Feed Rate.
To Next Page
Loading...