Gerber HS15 Plus - Adding the HS15 plus Plotter to System

10 HS15
plus
2. As the HS15
plus
performs self-check tests, the lights over the
RUN
CONT
,
RUN SINGLE
, and
SWIVEL KNIFE
keys flash twice, and two
additional beeps sound.
3. When the self-check tests are completed, the lights blink and the
beep sounds three times.
4. The plotter goes off-line in tangential knife mode. Only the power
light remains on. This is the initial setting at power-up.
Note: Rapid, continuous beeping and flashing lights may signal a
self-check error. See the “Error Conditions” section for more
information.
Adding the HS15
plus
Plotter
Use the GSP Setup program in the
GRAPHIX ADVANTAGE
to add the
HS15
plus
plotter to your system. Refer to your
GRAPHIX ADVANTAGE
Reference
for more information on setting up your system.
1. Double-click on the GSP Setup icon to open GSP Setup.
2. Click on Setup. The Setup drop-down menu appears.
3. Click on Plotter. The Add or Delete Plotter(s) Dialog Box appears.
4. Scroll through the list and click on
HS15
plus
in the Plotters list box to
highlight it.
5. Choose the port in the Ports box that you connected the plotter to.