48 HS15
plus
2. Apply a light coat of oil to the rear way and front way. Apply with a
lint-free cloth.
3. Tip the plotter on its left side.
CAUTION: Do not rest the plotter on its right side
.
Do not use
the way shaft to lift or turn the plotter.
4. Place one or two drops of oil on each side of the ball bushing and in
the oil hole (as indicated).
SPROCKETS AND BAIL ARMS
1. Inspect the teeth of the drum sprockets for adhesive buildup from
the use of vinyl films.
2. Use a small stiff brush (such as a toothbrush) dipped in isopropyl
alcohol to clean the sprockets.
3. After using isopropyl alcohol to clean them, immediately dry the
sprockets and drum with a lint-free cloth.
To Next Page
Loading...
