14 HS15
plus
CAUTION: When power is on, the carriage spindle must be
moved only by using the slew keys. Attempts to manually move
the plotter drum, rotate or force the tool up or down may
damage the plotter.
CAUTION: While power is off, center the carriage by gently
pushing toward the center of its travel. Take care to move the
carriage slowly and firmly by gripping the right end of the
carriage housing, not by gripping the carriage spindle.
CAUTION: Do not use the way shafts to lift or turn the HS15
plus
.
This can damage the system and reduce plotting accuracy.
2.
Center the carriage spindle preferably by using the slew keys (see
“Front Panel” section) or manually (with certain precautions, as
noted above). Be sure that the carriage spindle is not located at
either extreme end of its travel and that both ends of the rubber drum
can be reached easily.
3.
Open the bail arms at either end of the drum by pulling them up and
away from the drum.
4.
Using the slew (arrow) keys, rotate the drum until three closely
spaced pins are visible. These three sprocket pins are used to align
the material.
IDLER ROLLER
The idler roller prevents sandblast and static cling material from
jamming between the material and the moving parts of the plotter.
Sandblast and static cling material should be fed
under the idler roller,
as shown below.
To Next Page
Loading...
