Gerber HS15 Plus - Reset Key Functions; Error Codes and Operator Responses

Operation 37
RESET KEY
Use the
RESET
key to stop plotter operation in case of emergency, to
clear error signals, and to access Special Diagnostics at power up.
To cause an emergency stop
Press the
RESET
key while a job is plotting. The following sequence
occurs:
1. The HS15
plus
operation stops immediately.
2. Only the current job is cleared; all other jobs in the queue remain
intact.
3. The HS15
plus
returns to off-line status, as at power-up.
To clear an error signal
Press the
RESET
key to clear an error signal (rapid beeping and
flashing) after a power-up or plotting failure. (See the “Error
Conditions” section.)
To access diagnostics
Hold the
RESET
key at power-up to access additional diagnostics. (See
the “Special Diagnostics” section.)
RESET