Plotter Adjustments 53
Replacing Boards
If you need to change a board because of repair or update, refer to the
diagram and listed parts below when you talk to Gerber Field Service.
See the next page for the procedures to follow to access the board.
1 Z home connector 9 Logic board
2 Theta home connector 10 Control board
3 Encoder connector 11 Right side panel
4 RS232 connector 12 Keypad
5 4-motor power cable 13 Center hold-down screw
6 Power cable 14 White tabs
7 Keypad cable 15 Fuses
8 Keyboard extension cable
To Next Page
Loading...
