44 HS15
plus
DETERMINING ERROR NUMBERS
The number of beeps and blinking lights signify the type of error that
has occurred. Error conditions are assigned a 2-digit number. The
number is displayed by flashing lights and beeping, one digit at a time.
The
RUN CONT
key displays the first (tens) digit; the
RUN SINGLE
key
displays the second (ones) digit. For example, an error number of 25 is
displayed by pressing
RUN CONT,
which flashes lights 2 times, and
pressing
RUN SINGLE ,
which flashes 5 times. Follow the procedure
below to find the number of the error.
1. Press the
RESET
key to clear the error signal (continuous beeping).
2. Press the
RUN CONT
key to hear the number of beeps which
represent the “tens” error code number. (No beeps means that the
error message number falls between one and nine). The Run lights
flash the same number of times as the “tens” error number. Press the
RUN CONT
key again to repeat the message, if needed.
3. Press the
RUN SINGLE
key to hear the number of beeps which
represent the “ones” error code number. No beeps means that there
is no “ones” error number (a zero). The Run lights flash the same
number of times as the “ones” error number. Press the
RUN SINGLE
key again to repeat the message, if needed.
4. Press the
RESET
key to clear the error display mode and return to
the initial off-line status
The following examples may help you to understand how to determine
your error number:
If the
RUN CONT
key beeps twice and the
RUN SINGLE
key
beeps once, the error message code is 21.
If the
RUN CONT
key beeps once and the
RUN SINGLE
key
beeps twice, the error message code is 12.
If the
RUN CONT
key beeps once and the
RUN SINGLE
key
does not beep, the error message code is 10.
If the
RUN CONT
key does not beep and the
RUN SINGLE
key
beeps eight times, the error message code is 8.
To Next Page
Loading...
