50 HS15
plus
4. Pull out the light gray fuse carrier. Note that the carrier has a white
arrow on it pointing to the right (as do the two arrows on the black
plastic plate).
5. Remove any blown fuse. Install a new fuse of the same type and
rating (5-amp Slo-Blo) in the same place.
6. Reinsert the carrier, with the arrow pointing to the right. Be sure that
the carrier is inserted all the way. Close the black plastic plate
firmly.
7. Reinstall the power cord and the cable connector. Turn the power on
at the system and at the plotter.
To Next Page
Loading...
