Passwords
There are two passwords with different levels of authorisation in the system program:
Supervisor - contact service for code.•
Programming - contact service for code.•
Note: In the menu tree, where a password must be entered, there is a letter code (between PW:
A-K) which indicates which function the respective password level gives authorisation for.
When a password is being entered, the top line shows “ENTER PASSWORD”. Each di-
git can be changed with J and H. I and K toggle between the digits. Press S
toconrmtheenteredpassword.
Ifthewrongpasswordisentered,“WRONGPASSWORD”appearsontherstline.
Press S to return to the display that shows “ENTER PASSWORD”
Note: The password cannot be changed.
Supervisor
Code in menu tree Authority to change
A Parameters:
B Calender (time and date)
C Sensor calibration
D Acknowledge alarms
H Process-critical configurations, Parameters of type P
J Password configuration
K Documentation
Programming
Code in menu tree Authority to change
A Parameters:
B Calender (time and date)
C Sensor calibration
D Acknowledge alarms
E Service message
F DIP switches
G Non-critical system configurations
H Process-critical configurations, Parameters of type P
I Programming (phases and programs)
J Password configuration
K Documentation
To Next Page
Loading...
Need help?
General
