Setting detergent and rinse-aid quantities
This may only be done by authorized personnel. The machine is connected to
the electricity supply and some components are live.
Dispense 100 ml of the relevant substance into a measuring beaker. Check that the •
suction hose and pump are full before the check.
Push the suction hose down into the beaker and measure the consumption during an •
entire cleaning program. Lift up the hose when reading the volume. Adjust if neces-
sary and repeat the measurement until the amount conforms to the manufacturer’s
recommendations.
If necessary, adjust the dosing time in the service program.•
To Next Page
Loading...
