Connecting a barcode scanner
Hand scanner
To connect a barcode scanner, proceed as follows.
1. Connect power to the scanner.
2. Calibrate the scanner by reading in the barcodes below.
Scan in the top barcode. Wait for a beep, then scan in the
next code. Continue until all codes have been scanned in.
3. Connect a communication cable between the scanner and
port X24.
4. Set type of communication. The communication settings are done in the service pro-
gram; see Chapter Software description and settings.
- Go into Communication setup COM 0 (1.4.2.3.5.1); see Chapter 4 Software de-
scription and settings.
- Choose Scanner and press S. Exit the service program.
V1575
V1582
To Next Page
Loading...
Need help?
General
