Main menu 4, Settings (1.4)
Main menu 4 is the settings menu for the machine. The settings menu has three
submenus.
Print the parameters of the chosen cycle (1.4.1)
System setting menus. (1.4.2)
Appliance information. (1.4.3)
Print parameters of the chosen cycle (1.4.1)
When a cycle has been chosen in main menu 1, the parameters of that cycle can
be printed out.
Press
J three times to reach the settings menu, then press S to choose
settings. Pressing
S once more brings up the printing screen. Use I or
K to choose “YES” to start printing or “NO” if you do not want to print the
chosen cycle.
System menu (1.4.2)
The system settings menu has six submenus.
A calendar where you can enter the date and time. (1.4.2.1)
Calibration of analog entry values. (1.4.2.2)
Configuration of devices such as printer, alarms, alarm clocks
and node addresses. (1.4.2.3)
DIP switches. (1.4.2.4)
Service menu with fault message, service message and diagnostics. (1.4.2.5)
Save RAM in flash. (1.4.2.6)
Calendar menu (1.4.2.1)
The time and date can be set in this menu. There is a submenu for each function.
Set time. (1.4.2.1.1)
Set date. (1.4.2.1.2)
1.1
1.2
1.3
1.4
GETINGE PACS 300
VERSION 3.51 (0283)
P01 PROGRAM NAME
PARAM1 PARAM2
MACHINE NAME
PHASE NAME
CYCLE COUNTER
00000
SETTINGS
1.4.1
PRINT LAST CYCLE
SYSTEM
1.4.2
1.4.3
SYSTEM
ABOUT
SYSTEM
ABOUT
1.4.1.1
PRINT LAST CYCLE
YES NO
To Next Page
Loading...
Need help?
General
