EasyManuals Logo

Getinge 86 SERIES Technical Manual

Getinge 86 SERIES
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Page 21 of 174
<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Main menu 1, Program name (1.1)
In standby mode the top line of the display shows the name of the last
cycle chosen. The second row shows two preselected values. Normally the
temperature in the machine and the cycle counter are displayed. The main
purpose of this menu is to choose a wash cycle and to be able to change
parameters.
This menu has two submenus.
SELECT PROGRAM (1.1.1)
CHANGE PARAMETERS (1.1.2)
Choose program
In main menu 1, press S to go to the SELECT PROGRAM menu. Then press
Enter again to reach the various programs. Use the
J and H buttons to
highlight the program you want to use. To select a program press S. The cycles
are pre-configured in the program and cannot be changed by the operator.
1.1
1.2
1.1.1
1.3
1.4
GETINGE PACS 300
VERSION 3.51 (0283)
P01 PROGRAM NAME
PARAM1 PARAM2
MACHINE NAME
PHASE NAME
CYCLE COUNTER
00000
SETTINGS
CHOOSE A PROGRAM
1.1.1.1
0 PROGRAM #01
02 PROGRAM #02
1.1.1.2
1.1.1.3
02 PROGRAM #02
03 PROGRAM #03
03 PROGRAM #03
04 PROGRAM #04
1.1.1.9
1.1.1.10
1.1.1.11
09 PROGRAM #09
10 PROGRAM #10
10 PROGRAM #10
11 PROGRAM #11
11 PROGRAM #11
12 PROGRAM #12
1.1.2
CHANGE PARAMETERS

Table of Contents

Other manuals for Getinge 86 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Getinge 86 SERIES and is the answer not in the manual?

Getinge 86 SERIES Specifications

General IconGeneral
BrandGetinge
Model86 SERIES
CategoryCleaning Equipment
LanguageEnglish

Related product manuals