Getinge 86 SERIES Technical Manual

<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Page 28 of 174
Choose a sensor (1.4.2.2.2.2)
Press S when Choose sensor is highlighted under automatic calibration.
Confirm the choice by placing the cursor on “YES” and pressing S again. The
sensor has now been chosen. Note that more than one sensor can be chosen at
the same time. If more than one sensor is chosen at the same time, they must be
of a similar type.
1.1
1.2
1.4.1
1.3
1.4
GETINGE PACS 300
VERSION 3.51 (0283)
P01 PROGRAM NAME
PARAM1 PARAM2
MACHINE NAME
PHASE NAME
CYCLE COUNTER
00000
SETTINGS
PRINT LAST CYCLE
SYSTEM
1.4.2.1
CALENDAR
CALIBRATION
1.4.2.2
1.4.2.3
CALIBRATION
CONFIGURATION
CONFIGURATION
DIP SWITCHES
1.4.2.4
1.4.2.5
1.4.2.6
DIP SWITCHES
SERVICE
SERVICE
SAVE RAM IN FLASH
SERVICE
SAVE RAM IN FLASH
1.4.2
SYSTEM
ABOUT
ENTER PASSWORD*
1.4.2.2.1
1.4.2.2.2
1.4.2.2.3
MANUAL CALIBRATION
AUTO CALIBRATION
AUTO CALIBRATION
COMPENSATION TABLE
AUTO CALIBRATION
COMPENSATION TABLE
1.4.2.2.2.1
1.4.2.2.2.2
CONTINUE 1 (32)
CHOOSE SENSOR
1.4.2.2.2.2.1
1.4.2.2.2.2.2
1.4.2.2.2.2.3
00 CALIBRATION TYPE
VALUE % CAL NO
01 CALIBRATION TYPE
VALUE % CAL NO
02 CALIBRATION TYPE
VALUE % CAL NO
>
CONTINUE 1 (32)
CHOOSE SENSOR
>
1.4.2.2.2.2.31
31 CALIBRATION TYPE
VALUE % CAL NO
* Service personnel password required

Getinge 86 SERIES Specifications

General

Brand	Getinge
Model	86 SERIES
Category	Cleaning Equipment
Language	English