Getinge 86 SERIES - Aborting Program Start; Aborting a Running Program

<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Page 8 of 174
V1513
1 Pre-rinse 1
2 Pre-rinse 2
3 Wash
4 Neutralize
5 Post-rinse 1
6 Post-rinse 2
7 Final rinse
8 Disinfection
9 Drying
Program cycles
A Alkaline detergent
B Neutralisation
C Instrument milk
(extra equipment)
If instrument milk is
dosed, neutralisa-
tion is not dosed.
90
80
70
60
50
40
30
20
10
100
10 20 30 40 50 60 min
5
CW HWHW
(DW
option)
A
B
9
3 861
HWCW+HW
7
(C)
Aborting program start
A started program can be aborted within ten seconds of the door being locked. To abort
a started program, press V again. During the period when the program can be abort-
ed,ayellowlampashesat M. The door is unlocked and opened automatically and
the machine can be restarted in the usual way.
Aborting a running program
While a program is running, the machine can be stopped with the main switch.
If the power is switched on again within 60 seconds, the program continues un-
til the end. If the power is switched back on after more than 60 seconds, fault code
F00 PWR FAILUREisdisplayed.Toacknowledgethealarm,rstsilencetheaudible
signal by pressing U. When the fault has been corrected, enter the password and con-
rmbypressingS.Allliquidisdrainedfromthemachineandthesoiled-sidedooris
unlocked and goes down.