Function check
This may only be done by authorized personnel.
The machine is connected to the electricity supply and some components
are live.
Instruction manual, cable, switch
Check that a goods placing sign has been put up on the wall behind the disinfector.•
Check that the isolator switch on the wall is working and that the connecting cable •
is undamaged and free from defects.
Filters and valves
Check that level switches and manual shutoff/opening valves are working properly.•
Checktheltersinthesupplyline(seeunderCleaningtheltersinthesupply•
line). Clean if necessary.
Check all pipe couplings. Tighten and seal if necessary.•
Controls
The machine is operated with the buttons on the control panel. •
Check that the control buttons are working. If the buttons are working, a beep will •
be heard.
While a program is running check that the yellow lamp at • M is lit.
When the program is complete, the green lamp at • N should light up.
Insert for goods
Check that the inserts for the machine dock properly with the water outlets.•
Checkthatsprayarms(iftted)rotateandarenotclogged.•
Check that the goods to be cleaned are retained in the insert.•
Door
Check that the door seal closes tight and is undamaged and that there is no leakage
while a program is running. Clean or replace the seal if necessary.
V190
Container alarm
To Next Page
Loading...
Need help?
General
