Fault codes
The fault codes indicate that the monitoring system has detected serious fault in the
machine or in the current wash program. All fault coders in the monitoring system must
be acknowledged on the washer disinfector’s control panel.
The fault must be put right by an authorised service technician. Afterwards, the collec-
tive alarm must be reset by entering the password on the machine’s control panel. The
fault code is then automatically reset in the monitoring system.
The following fault codes may occur:
Fault code Description of fault
F00 Faulty (controlling) temperature sensor in washing chamber
F01 Faulty (independent) temperature sensor in washing chamber
F02 Low pressure from circulation pump.
F04 Incorrect temperature in washing chamber. (Sensor fault)
F05 Low pressure in circulation line.
F06 High pressure in circulation line.
F08 Low flow from dosing pump 1.
F09 Low flow from dosing pump 2.
F10 Low flow from dosing pump 3.
F11 Low flow from dosing pump 4.
F13 High conductivity in the disinfection phase.
F14 Incorrect disinfection time.
F15 Low disinfection temperature.
F16 Fault message from control system.
F17 Power outage (Emergency stop)
To Next Page
Loading...
Need help?
General
