5-26
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
Setting the Low Movement Speed
This setting determines the slower speed when one of the [ ] [ ] [ ] [ ] keys is initially pressed, and
the length (distance) before faster movement begins.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
OPTION1 OPTION2
(3) Press the [F4] key (OPTION2) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
POSITION OPT
MOVE SPD TEST
(4) Press the [F3] key (POSITION OPT) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
STEP HI SPEED
LOW SPEED LCD
•
(5) Press the [F2] key (LOW SPEED) to display the low-speed setting screen.
FORCE OFFSET
SPEED QUALITY
LOW SPEED 2 cm/s
LENG 5 cm
Press the [F3] key (LOW SPEED) to specify the speed for low-speed movement. Press the [F4] key (LENG) to
specify the length (distance) moved before the low-speed movement changes to high-speed movement begins.
Use the [ ] or [ ] key to change the numeric value and then press the [ENTER] keytoconrmyourselections.
To cancel your selections, press the
[NEXT] key.
Setting range: [LOW SPEED] 1 to 30 (cm/s) [Default value: 2]
[LENG] 0 to 30 (cm/s), MAX [Default value: 10]
If 0 was selected for the LENG parameter, the pen carriage starts moving at the high speed. If the
[NEXT] key is
held down, however, the pen carriage moves at the low speed.
If MAX was selected for the LENG parameter, the pen carriage moves at the low speed without switching to the high
speed. If the [NEXT] key is pressed during pen carriage movement, however, the pen carriage switches to the high
speed.
(Default values: LOW-SPEED: 2 cm/s; LENG: 2 cm)
(6) Press the
[PAUSE] key to cancel PAUSE mode.
This setting is retained in the plotter's internal memory even while the plotter is turned off.
To Next Page
Loading...
