5-27
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
Setting the High Movement Speed
This setting determines the high speed setting when one of the [ ] [ ] [ ] [ ] keys is held down.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
OPTION1 OPTION2
(3) Press the [F4] key (OPTION2) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
POSITION OPT
MOVE SPD TEST
(4) Press the [F3] key (POSITION OPT) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
STEP HI SPEED
LOW SPEED LCD
•
(5) Press the [F3] key (HI SPEED) to display the high-speed setting screen.
FORCE OFFSET
SPEED QUALITY
HI SPEED 20 cm/s
Use the [ ] or [ ] key to change the numeric value and then press the [ENTER] keytoconrmyourselections.
To cancel your selections, press the
[NEXT] key.
Setting range: 1 to 30 (cm/s) [Default value: 20]
(6) Press the
[PAUSE] key to cancel PAUSE mode.
This setting is retained in the plotter's internal memory even while the plotter is turned off.
To Next Page
Loading...
