4-20
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
If the value you input is exceedingly large (1.5 times or greater) or very small (0.5 times or less), or if the angle of tilt
with respect to the original axis tilt is 45° or greater, the following prompt is displayed. In this case, please re-input
the value.
FORCE OFFSET
SPEED QUALITY
DISTANCE ADJUSTMENT
ERROR. SET AGAIN!
(5) If 3-point or 4-point adjustment has been selected, the menu for adjusting the distance between points 1 and 3 will
be displayed. Make the settings in the same way as for the distance between points 1 and 2.
(6) When the distances between all the points have been adjusted, the following menu for setting the axis adjustment
origin is displayed. (This menu is not displayed when 4-point reading has been selected.)
FORCE OFFSET
SPEED QUALITY
AXIS ORIGIN POINT
X= 0 Y= 0
Use the [ ] [ ] [ ] [ ] keys to move the pen carriage (the tip of the tool or pen selected by the current setting)
to the position for setting the axis adjustment origin, and then press the
[ENTER] key. If 2-axis adjustment has been
performed previously, the pen carriage will move automatically to the previously set reference point. In this case, use
the [ ] [ ] [ ] [ ] keys to make any adjustments required.
(7) When all the adjustments have been completed, the plotter returns to Ready status.
To Next Page
Loading...
