GRAPHTEC FC2250 Series - Cutter Pen Component Identification

2-3
Chapter 2 CUTTER BLADES, CUTTER PENS AND PENS
2.2 Cutter Pen Nomenclature
Handle cutter blades with care!
PHP31-CB09-HS
Cutter pen for 0.9-mm diameter blades
* The CB09UA supersteel blade is shown in the figure above.
Protective cap Plunger Holder A Spring Cutter blade* Holder B Plunger cap
Blade length adjustment knob (blue)
PHP31-CB15-HS
Cutter pen for 1.5-mm diameter blades
* The CB15U supersteel blade is shown in the figure above.
Protective cap Plunger Holder A Cutter blade* Holder B Plunger cap
Blade length adjustment knob (red)
PHP31-CB15B-HS
Cutter pen for 1.5-mm diameter blades tted with a spring
* The CB15U-SP supersteel blade is shown in the figure above.
Protective cap Plunger Holder A Spring Cutter blade* Holder B Plunger cap
Blade length adjustment knob (green)
PHP31-CB15B-HS
Cutter pen for 3.0-mm diameter blades tted with a spring
* The CB30UC supersteel blade is shown in the figure above.
Protective cap PlungerSpring Cutter blade* Holder
Blade length adjustment knob (silver)