GRAPHTEC FC2250 Series - Printing a Conditions List

5-28
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.24 Printing a Conditions List
This function allows you to print a list of the current cutting/plotting settings (conditions).
The pen carriage starts moving as soon as this function has been selected. To avoid injury to yourself or damage to
the plotter, keep your hands and other obstacles out of the vicinity of any moving parts.
(1) If you want to print out the list of cutting/plotting conditions of one sheet of paper, load a sheet of paper that is A3
sizeorlargerintheplotter.
Ifyouwanttoprintoutthelistontwosheetsofpaper,loadanA4-sizesheetofpaperintheplotter.
(2) Mount a plotting pen.
(3) Press the
[PAUSE] key to select PAUSE mode.
(4) Press the
[NEXT] key until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
OPTION1 OPTION2
(5) Press the [F4] key (OPTION2) to display the following menu.
FORCE OFFSET
SPEED QUALITY
POSITION OPT
MOVE SPD TEST
(6) Press the [F4] key (TEST) to display the following menu.
FORCE OFFSET
SPEED QUALITY
SELF TEST
COND. PAT. DUMP
(7) Use the [ ] [ ] [ ] [ ] keys to move the pen carriage (the tip of the tool selected by the current setting) to the
position where you want to print the list. Next, press the
[F2] key (COND. PAT.). The following message appears on
the LCD and the plotter begins printing "Condition Settings Page 1".
FORCE OFFSET
SPEED QUALITY
PRINT CONDITIONS
(8) When this page has been printed, the following message appears on the LCD.
FORCE OFFSET
SPEED QUALITY
LOAD PAPER !!
PRESS ENTER KEY
Replace the medium if required or use the [ ] [ ] [ ] [ ] keys to move the pen carriage (the tip of the tool
selected by the current setting) to the position where you want to print the second list.
Press the [ENTER] key to print "Condition Settings Page 2"
(9) When all of the conditions have been printed, the READY message reappears.