GRAPHTEC FC2250 Series - PAUSE Menu Configuration

5-2
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.1 PAUSE Menu Conguration
When the plotter is in PAUSE mode, each of the functions listed below can be accessed by pressing the
[NEXT] key
until the desired menu appears and then pressing function key
[F1] [F2] [F3]
or
[F4]
to select
the desired menu parameter.
MARK TOOL U/D BUFFER CLR. VIEW
20,20 COND1 09U 0 30 PAUSE+ TOOL1 4
I/F FUNCTION TOOL COND AREA OPT
THICK CUT LINE TOOL No. ADJ.T POS RS-232C COMMAND
MODE DIST ADJ TYPE OTHER SETUPS
SIZE ADJ. SENS ORG OFT SENS OPT
LEVEL SENS SPD SENS STEP
THICK No. OVERLAY
B.G. SETTINGS DIST. ADJ SORTING ROTATE MIRROR L.L. U.R. SCALE
OPTION1 OPTION2
START FCE OFST ANG OFST FCE STP PASS
POSITION OPT MOVE SPD TEST
STEP HI SPEED LOW SPEED LCD
•
SELF TEST COND. PAT. DUMP
5.25 Printing the Self-Test Pattern
5.26 Printing a Character Dump List5.24 Printing a Conditions List
5.22 Setting the Tool
Movement Speed
5.20 Setting the Offset Angle
5.21 Setting the Step Pass5.19 Setting the Offset Force
5.18 Setting the Initial Cutting Force
5.16 Setting the Mirror Mode
5.17 Scaling the Image Data5.15 Setting the
Cutting/Plotting Area
5.14 Rotating the Coordinate Axes
5.27 Special Functions
5.13 Sorting5.12 Setting the Distance Adjustment Values5.6 Setting the Data Format to be Received5.5 Setting the Communication
Conditions
5.8 Setting the Overlay
Function
5.7 Assigning THICK Mode
5.10 Assigning Perforation Cutting
5.11 Setting the Tool Interval
Adjustment Value
5.9 Assigning Tool Numbers
5.3 Raising/Lowering the Tool
5.4 Moving the Pen Carriage
to the Upper Right Position
5.2 Clearing the Buffer
CHAPTER 4 Registration Mark
Settings and Detection
5.23 Setting the Pen Carriage
Movement Speed
[NEXT] key [NEXT] key [NEXT] key [NEXT] key