GRAPHTEC FC2250 Series - Specifying Registration Mark Dimensions

4-9
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.5 Setting the Registration Mark Size
Thisfunctionallowsyoutospecifythesizeoftheregistrationmarksdrawnonthemedium.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(3) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(4) Press the [F4] key (OTHER SETUPS) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(5) Press the [F1] key(SIZE)todisplaythemenuforsettingtheregistrationmarksize.
FORCE OFFSET
SPEED QUALITY
MARK SIZE
15 mm
Use the [ ] or [ ] key to change the numeric value, and then press the [ENTER] keytoconrmyourselection.
Setting range: 5 to 20 (mm)
Registration mark pattern 1,
Mirror 1
Registration mark pattern 3
Registration mark pattern 2,
Mirror 2
Set value
Set value
Set value
Set value
Set value
Set value
(6) Press the [PAUSE] key to cancel PAUSE mode.