GRAPHTEC FC2250 Series - PerforatOn SettNgs

3-15
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(4) The active mode is indicated by the [
•
] mark. Press the [F1] and [F3] key to move the [
•
] mark between Mode 1 and
Mode 2 and select the desired mode.
Mode 1: Perform overcutting for the cutting start and end points and for corners with acute angles to prevent uncut
areas. Since the blade tip is raised up to the surface of the medium when blade rotation is large, it is not
affectedbythickorhardmedia.ComparedwithMode2,thismodesupportsnercuttingandcuttingof
thicker media.
Mode 2 : Perform overcutting for the cutting start and end points only. Compared with Mode 1, this mode supports
faster cutting, since less cutter blade control is required.
(5) Use the
[F2] key to move the blinking cursor to the Start point parameter and the [F4] key to move it to the End
point parameter. Use the
[ ] or [ ] key to change the value.
Setting range: 0 to 3.0 mm
(6) When the displayed settings are correct, press the
[ENTER] key. The display will change to the screen for setting
the perforation length. To cancel your settings, press the
[NEXT] key.
Perforation Settings
This setting determines the cut and uncut lengths of a perforated line. This setting is only enabled for the
COND Nos. to which the perforation mode has been assigned.
•
The perforation settings are disabled when "PEN", "CP001" or "CP002" has been selected as the cutter blade type.
•
Please see Section 5.10, "Assigning Perforation Cutting" for further details.
(1) Whenperforationcuttinghasbeenspecied,"M"isdisplayednexttotheToolNo.whentheplotterisinReadystatus.
FORCE OFFSET
SPEED QUALITY
20,20 COND1 09U 0
30 READY+ TOOL1M 4
(2) Press the [CONDITIONS] key to display the following screen. (The display will differ according to the setting
conditions that have been made.)
FORCE OFFSET
SPEED QUALITY
X20 COND1 09U 0
30 CHANGE TOOL1 4
(3) Press the [ENTER] key to display the Thick Mode mode selection screen (only when Thick Mode assignment has
been performed).
FORCE OFFSET
SPEED QUALITY
• MODE THICK MODE2
STR.=0.0mm END=0.0mm
(4) Press the [ENTER] key to display the screen for setting the Perforation Mode values.
FORCE OFFSET
SPEED QUALITY
C LINE PAT.SETTING
C=00.25mm U=00.25mm
(5) "C" represents the cut length, while "U" represents the uncut length, Use the [ ] or [ ] key to move the blinking
cursor to the parameter that you wish to change, and the
[ ] or [ ] key to change the value.
Setting range: 0 to 99.99 mm
(6) When the displayed settings are correct, press the
[ENTER] key. To cancel your settings, press the [NEXT] key.