GRAPHTEC FC2250 Series - Rotating the Coordinate Axes

5-15
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.14 Rotating the Coordinate Axes
Thisfunctionisusedtomovetheoriginandrotatethecoordinateaxesby90°asshowninthegurebelow.
Origin in ROTATE mode
Coordinates when
ROTATE mode is not selected (OFF)
Coordinates when
ROTATE mode is selected (ON)
X
Y
Y
X
Origin
Y
X
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the [F4] key (AREA OPT) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
ROTATE MIRROR
L.L. U.R. SCALE
(4) Press the [F1] key (ROTATE) to display the coordinate rotation setting screen.
FORCE OFFSET
SPEED QUALITY
ROTATE
ON OFF •
The current setting is indicated by a black dot [
•
].
To select ROTATE mode, press the [F2] key (ON).
To cancel ROTATE mode, press the [F4] key (OFF).
After you have selected the desired parameter, press the
[ENTER] keytoconrmyourselection.
(5) Press the
[PAUSE] key to cancel PAUSE mode.
This setting is retained in the plotter's internal memory even while the plotter is turned off.