I
PREFACE
PREFACE
Thank you for purchasing an FC2250 Series Cutting Plotter. This plotter incorporates a digital servo drive to
perform cutting and plotting operations at high speed and high precision.
Besides being used to cut marking film, sandblast rubber, rubber stencil sheets and other media, this plotter
can also be used as a pen plotter.
To ensure opt
This product is manufactured and sold pursuant to a license under Gerber Scientific International, Inc.'s U.S.
Patent No. 5,537,135 and its foreign counterparts.
imum use of the plotter’s various functions, be sure to read this manual thoroughly before use.
Notes on the Use of This Manual
•
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any
form or by any means, without the prior written permission of Graphtec Corporation.
•
The specifications and other information in this manual are subject to change without notice.
•
While every effort has been made to supply complete and accurate information about this product, please address
any inquiries about unclear information, possible errors, or other comments to your sales representative or nearest
Graphtec vendor.
•
Notwithstanding the preceding paragraph, Graphtec Corporation assumes no liability for damages resulting from the
use of the information contained herein or of the product.
Registered Trademarks and Copyrights
•
HP-GL™ is the registered trademark of Hewlett-Packard Company.
•
All copyrights regarding this manual belong to Graphtec Corporation.
To Next Page
Loading...
