GRAPHTEC FC2250 Series - SettNg the QualTy [QUALITY]

3-14
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
Setting the Quality [QUALITY]
This setting determines the quality of the cut or plotted results. Please see Section 3.10, "Media and Cutting
Conditions" for further details on the setting values.
(1) With the plotter in Ready status, press a key from [F1] to [F4] to select the COND No. that you wish to change.
(2) Press the
[CONDITIONS] key to display the following screen. (The display will differ according to the setting
conditions that have been made.)
FORCE OFFSET
SPEED QUALITY
X20 COND1 09U 0
30 CHANGE TOOL1 4
(3) Press the [F4] key to move the blinking cursor to the QUALITY parameter.
FORCE OFFSET
SPEED QUALITY
X20 COND1 09U 0
30 CHANGE TOOL1 4
(4) Use the [ ] or [ ] key to change the value.
Setting range: 1-6
The smaller the number, the higher the quality
(5) When the displayed settings are correct, press the
[ENTER] key. To cancel your settings, press the [NEXT] key.
Thick Mode Settings
The Thick Mode is used for cutting thick media such as rubber for sandblasting masks and thick paper for
garmentpatternsaswellashardmediasuchasacryliclm.ThissettingisonlyenabledfortheCONDNos.
to which THICK mode has been assigned.
•
Thick Mode is not enabled when "PEN" or "CP001" has been selected as the cutter blade type.
•
Please see Section 5.7, "Assigning Thick Mode" for further details.
(1) WhenThickModehasbeenspecied,theblinkingcursorisdisplayedlocatedovertheToolNo.whentheplotteris
in Ready status.
FORCE OFFSET
SPEED QUALITY
20,20 COND1 09U 0
30 READY+ TOOL1 4
(2) Press the [CONDITIONS] key to display the following screen. (The display will differ according to the setting
conditions that have been made.)
FORCE OFFSET
SPEED QUALITY
X20 COND1 09U 0
30 CHANGE TOOL1 4
(3) Press the [ENTER] key to display the Thick Mode mode selection screen (only when thick mode assignment has
been performed).
FORCE OFFSET
SPEED QUALITY
• MODE THICK MODE2
STR.=0.0mm END=0.0mm