GRAPHTEC FC2250 Series - Activating Mirror Image Plotting

5-18
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.16 Setting the Mirror Mode
When MIRROR mode is selected using this function, the origin and coordinate axes are inverted as shown
inthegurebelow.
MIRROR mode is not selected (OFF)
X
Y
Origin
Y
X
MIRROR mode is selected (ON)
X
Y
Origin when MIRROR mode is selected
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the [F4] key (AREA OPT) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
ROTATE MIRROR
L.L. U.R. SCALE
(4) Press the [F3] key (MIRROR) to display the MIRROR mode setting screen.
FORCE OFFSET
SPEED QUALITY
MIRROR
ON OFF •
The current setting is indicated by a black dot [
•
].
To select MIRROR mode, press the [F2] key (ON).
To cancel MIRROR mode, press the [F4] key (OFF).
After you have selected the desired parameter, press the
[ENTER] keytoconrmyourselection.
(5) Press the
[PAUSE] key to cancel PAUSE mode.
•
When the plotter is turned off, the MIRROR mode returns to its default setting (OFF).
•
The MIRROR mode is set to OFF when MARK TYPE 3 is selected.