GRAPHTEC FC2250 Series - Adjusting Registration Mark Origin Offset

4-10
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.6 Setting the Registration Mark Offset
The default position of the origin point is the lower left corner of the cutting/plotting area. Use this function
whenever you wish to move the registration mark origin point.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(3) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(4) Press the [F4] key (OTHER SETUPS) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(5) Press the [F2] key (ORG OFT) to display the menu for setting the registration mark offset.
FORCE OFFSET
SPEED QUALITY
OFFSET(mm)
X= 0000.0 Y= 0000.0
Use the [ ] or [ ] key to move the blinking cursor, and the [ ] or [ ] key to change the numeric value. When
the displayed settings are satisfactory, press the
[ENTER] keytoconrmyourselections.
Registration mark pattern 1 Registration mark pattern 2 Registration mark pattern 3
Registration mark origin
Cutting/plotting
origin
Registration mark origin
Registration mark pattern Mirror 2
Registration mark pattern Mirror 1
: Cutout area
: Cutout area
X
Y
Registration mark origin
X
Y
Registration mark origin
Cutting/plotting
origin
X
Y
Cutting/plotting
origin
X
Y
Registration mark origin
Cutting/plotting
origin
X
Y
Cutting/plotting
origin
(6) Press the [PAUSE] key to cancel PAUSE mode.