4-11
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.7 Adjusting the Registration Mark Sensor
This function allows you to adjust the registration mark sensor. Two adjustment methods are provided—use
the one that best suits your requirements.
Adjusting the Registration Mark Sensor by Using a Pre-printed Cross Symbol and a Plotted Cross Symbol
This function allows you to adjust the registration mark sensor by reading a pre-printed cross symbol, and then plotting
another cross symbol for use in adjustment. The sensor’s precision is adjusted by inputting the difference in the values
of these two cross symbols.
Perform this adjustment after the registration mark detection level and registration mark detection speed settings
have been made.
(1) Load a medium with a pre-printed cross symbol in the plotter.
(2) Mount a plotting pen in tool holder 1.
(3) Press the
[CONDITION] key to display a condition settings screen, and then use the [F1] to [F4] keys to select a
COND No. where "PEN" has been selected as the cutter blade type.
(4) Press the
[PAUSE] key to select PAUSE mode.
(5) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(6) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(7) Press the [F4] key (OTHER SETUPS) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(8) Press the [F3] key (ADJ. SENS) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
X ADJUST SENS. Y
X+ Y+
(9) Press the [F1] key (X) to adjust the X-axis sensor, and the [F3] key (Y) to adjust the Y-axis sensor.
FORCE OFFSET
SPEED QUALITY
MOVE TO ADJ. POINT
PRESS ENTER KEY!
To Next Page
Loading...
