GRAPHTEC FC2250 Series - Selecting Registration Mark Patterns

4-5
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.3 Setting the Registration Mark Pattern
Yourplottercanreadveregistrationmarkpatterns:1,2,3,Mirror1andMirror2.Ifpattern3,Mirror1or
Mirror 2 has been selected, this function allows you to set the spacing between the registration mark line
segments.
Registration mark pattern 1 Registration mark pattern 2 Registration mark pattern 3
Registration mark pattern Mirror 1 Registration mark pattern Mirror 2
: Cutout area : Cutout area
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(3) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(4) Press the [F1] key (TYPE) to display the menu for setting the registration mark pattern.
FORCE OFFSET
SPEED QUALITY
1 MARK TYPE 3
• 2 MIRROR
The currently selected setting is indicated by a black dot [
•
].
To read registration mark pattern 1, press the
[F1] key (1).
To read registration mark pattern 2, press the
[F2] key (2).
To read registration mark pattern 3, press the
[F3] key (3).
To read registration mark pattern mirror 1 or mirror 2, press the
[F1] key (1) or the [F2] key (2) together with the [F4]
key (MIRROR).
When the displayed setting is satisfactory, press the
[ENTER] keytoconrmyourselection.
If registration mark pattern 3 has been selected, the mirror mode setting (see Section 5.16, "Setting the Mirror
Mode" will be set to off.