GRAPHTEC FC2250 Series - Page 55

4-4
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
To perform manual axis adjustment using a pre-printed frame or other marks on the medium as reference points,
press the [F2] key (AXIS).
To perform automatic or manual detection of the registration marks, press the
[F4] key (MARKS).
When the displayed setting is satisfactory, press the
[ENTER] keytoconrmyourselection.
(5) When the
[F2] key (AXIS) or [F4] key (MARKS) is pressed, the axis adjustment menu is displayed.
FORCE OFFSET
SPEED QUALITY
3 POINT
2 POINT 4 POINT •
Press the [F2], [F3] or [F4] key to display the black dot next to your desired mode and then press the [ENTER] key
toconrmyourselection.IfAXISwasselectedfortheregistrationmarkmodetheplotterreturnstoReadystatus.
(6) If MARKS was selected for the registration mark mode, the MARK MOVE No. menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK MOVE No.
No.=1
By specifying the distance between registration marks and not performing scanning in the areas where there are no
registration marks, this function enables a reduction in the time required to read registration marks and also prevents
the misreading of dirt or other foreign matter on the medium as a registration mark. Up to three settings can be
registered.
(7) Use the
[ ] or [ ] key to move through the selections "1", "2," and "3". Select the number that you wish to register
and then press the [ENTER] key.
FORCE OFFSET
SPEED QUALITY
MARK MOVE No.
No.=1
(8) Next, the MARK MOVE DIST. menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK MOVE DIST.
X=0000mm Y=0000mm
Use the [ ] or [ ] key to move the blinking cursor, and the [ ] or [ ] key to change the numeric value. Press
the [ENTER] keytoconrmyourselections.
Specify [Y]
Specify [X] Specify [X]
Specify [Y] Specify [Y]
Specify [X]
Registration mark pattern 1 Registration mark pattern 2 Registration mark pattern 3
If there is no need to skip reading between registration marks, specify X = 0, Y = 0 (the default values). If 0 mm is
speciedforthespacing,theplotterwillnotskipreadingbetweenregistrationmarks.Itwillcontinuesearchinguntil
the next registration mark is found.
If 2-point reading has been selected, the Y numeric value is disregarded.