GRAPHTEC FC2250 Series - Page 41

3-13
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(5) Use the [ ] or [ ] key to move the position of the blinking cursor, and the [ ] or [ ] key to select the value.
Setting range: 0 to 9.99 mm
Mode 2 (Crease two lines) Mode 3 (Crease three lines)
Actual data
(creasing is not performed
at the actual data position)
Spacing
Actual data
Spacing
Setting the Number of Creasing Operations
(6) Press the [F3] key to move the blinking cursor to the position shown in the following screen.
FORCE OFFSET
SPEED QUALITY
MODE2 COUNT1
SPC 1.00mm ST 0.00mm
(7) This setting determines how many times creasing should be repeated for each line segment. Use the [ ] or [ ]
key to select the value.
Setting range: 1 to 9 (times)
Setting the Start and End Positions
(8) Press the [F4] key to move the blinking cursor to the position shown in the following screen.
FORCE OFFSET
SPEED QUALITY
MODE2 COUNT1
SPC 1.00mm ST 0.00mm
(9) This setting determines by what margin each end of the creasing line falls short of the corresponding end of the actual
data line. Use the
[ ] or [ ] key to move the blinking cursor, the [ ] or [ ] key to change the numeric value and
the [ENTER] keytoconrmyourselections.
Setting range: 0 to 9.99 (mm)
CP-002/003CP-001
Actual data
Specified value
Medium
Actual data
Specified value
Medium
(10) When all the displayed values are correct, press the [ENTER] key. To cancel your settings, press the [NEXT] key.
For short-line data such as circle command data, setting a large value for the ST (Start) parameter may result in creasing
not being performed.