4-8
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
(3) If the registration mark mode setting was 3-point reading or 4-point reading, the menu for adjusting the distance
between points 1 and 3 will be displayed. Make the settings in the same way as for the distance between points 1
and 2.
(4) When adjustment has been completed, the plotter returns to Ready status.
CUSTOM
(1) Press the [F3] key (CUSTOM) in the registration mark distance adjustment menu.
FORCE OFFSET
SPEED QUALITY
10mm
•
5mm 50mm
The currently selected setting is indicated by a black dot [
•
].
To select the 5 mm distance adjustment divisor value, press the
[F2] key.
To select the 10 mm distance adjustment divisor value, press the
[F3] key.
To select the 50 mm distance adjustment divisor value), press the
[F2] key.
When the displayed setting is satisfactory, press the
[ENTER] key.
To Next Page
Loading...
