GRAPHTEC FC2250 Series - Page 115

6-5
Chapter 6 TROUBLESHOOTING
GP-GL Command Mode Error Messages
If any of the following error messages are displayed, one of the following reasons is like to be the cause:
(1) The software’s output or interface settings have been changed.
gCongurethesoftwareforoutputbythisplotter.
g Ensure that the software’s interface settings are correctly set.
(2) The plotter’s interface settings have been changed.
g Ensure that the plotter’s interface settings are correctly set.
Error message Cause Solution
ERROR 1
COMMAND ERROR !
Theplotterreceivedanunrecognizable
command.
•
The software’s output or interface settings
have been changed.
Congurethesoftwareforoutputbythis
plotter.
Ensure that the software’s interface settings
are correctly set.
•
The plotter’s interface settings have been
changed.
Ensure that the plotter’s interface settings
are correctly set.
ERROR 4
PARAMETER OVERFLOW
A command containing a numeric parameter
that exceeds that command's permissible
range was received.
•
The software’s output or interface settings
have been changed.
Congurethesoftwareforoutputbythis
plotter.
Ensure that the software’s interface settings
are correctly set.
•
The plotter's interface settings have
been changed.
Ensure that the plotter’s interface settings
are correctly set.
ERROR 5
I/O ERROR !
An interface-related error occurred during
data transfer.
Congurethesoftwareforoutputbythis
plotter.
•
The software’s output or interface settings
have been changed.
Congurethesoftwareforoutputbythis
plotter.
Ensure that the software’s interface settings
are correctly set.
•
The plotter's interface settings have
been changed.
Ensure that the plotter’s interface settings
are correctly set.