GRAPHTEC FC2250 Series - Page 4

iii
Safety Precautions
Safety Precautions
Avoid direct contact with the cutter blade.
•
Touching the blade with your bare hand may cause injury.
•
During a cutting operation, keep away from the cutter blade.
No touching
Do not use or store the plotter in a location exposed
to direct sunlight or the direct draft of an air
conditioner or heater.
•
Such location may impair the performance
of the plotter.
Prohibited
Do not use or store the plotter in an excessively
dusty or humid location.
•
Such location may impair the performance of the plotter.
Prohibited
Do not install, use, or store the plotter in a location
subject to excessive mechanical vibration or
electrical noise.
•
Such location may impair the performance of the plotter.
Prohibited
Do not place a coffee cup or any other receptacle
containing water or other uid on top of the plotter.
•
Fluid falling inside the plotter may cause electrical shock or a
rehazardduetocurrentleakage.
Avoid water
Beware of
electrical shock
Do not allow dust or metallic matter to adhere to the
power plug.
•
Adirtypowerplugmayresultinelectricalshockorare
hazardduetocurrentleakage.
Prohibited
Beware of
electrical shock
Do not use the power cord if it is damaged.
•
Useofadamagedcordmayresultinelectricalshockorare
hazardduetocurrentleakage.
•
Replace the power cord with a new one.
Unplug the power
cord from the socket