GRAPHTEC FC2250 Series - Defining Mark Detection Start Point

4-25
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
4.14 Setting the Registration Mark Detection Start Position
This function sets the start position for registration mark detection.
(1) Select either AXIS or MARKS for the registration mark mode (see Section 4.2, "Setting the Registration Mark Mode".
(2) With the plotter in Ready status, press the
[ORIGIN] key to display the following menu.
FORCE OFFSET
SPEED QUALITY
1 3
2 MANUAL
(3) Press the [NEXT] key to display the following menu.
FORCE OFFSET
SPEED QUALITY
MIRROR MARKS
START POS
(4) Press the [F2] key (START POS) to display the menu for setting the start position for the reading of registration
marks.
FORCE OFFSET
SPEED QUALITY
• SAVE POS ORG POS
CURRENT POS AUTO •
The currently selected setting is indicated by a black dot [
•
].
To save the current position and use it as the start position for the next registration mark detection operation, press
the [F1] key (SAVE POS).
To start registration mark detection from the current pen carriage position, press the
[F2] key (CURRENT POS).
To start registration mark detection from the origin point, press the
[F3] key (ORG POS).
If the [F4] key(AUTO)ispressed,thesensorperformsdetectionwhilemovinginadiagonaldirectioniftherst
registration mark (the registration mark at the lower left position) is not detected from the current start position.
When the displayed setting is satisfactory, press the
[ENTER] keytoconrmyourselection.